We can also get or check the addresses using the Arduino I2C Scanner sketch which can be found from the Arduino official website. See Also Arduino and MPU6050 Accelerometer and Gyroscope TutorialДЇor the GY-521 breakout board we have only one address and thatвЂ™s a hexadecimal 0ењ†8. So we can get data from 8 different sensors with just two wires with the I2C bus. ExampleДЄs an example I will use the GY-80 breakout board which consists 5 different sensors and the GY-521 breakout board which consists 3 different sensors. After the data is completely sent, the transfer will end with a stop condition which occurs when the SDA line goes from low to high while the SCL line is high. These addresses can be found from datasheet of the sensor.ДЄfter the addressing, the data transfer sequences begin either from the master or the slave depending of the selected mode at the R/W bit. So if we want to read the data of the X-axis, first we need to send the device address and then the particular internal register address for the X-axis. For example the ADX345 Accelerometer has a unique device address and addition internal registers addresses for the X, Y and Z axis. The internal registers are locations in the slaveвЂ™s memory containing various information or data. Next is the internal registers addressing. The device addressing sequence stars with the most significant bit (MSB) first and ends with the least significant bit (LSB) and itвЂ™s actually composed of 7 bits because the 8 th bit is used for indicating whether the master will write to the slave (logic low) or read from it (logic high). After this the clock starts and each data bit is transferred during each clock pulse. The start condition occurs when data line drops low while the clock line is still high. LetвЂ™s take even closer look at these events. Right after the addressing sequences follows the data sequences as many until the data is completely sent and it ends with a special stop condition.

After the first Acknowledge bit in most cases comes another addressing sequence but this time for the internal registers of the slave device.

After each 8 bits sequence follows a bit called Acknowledge. So after a special start condition occurs comes the first 8 bits sequence which indicates the address of the slave to which the data is being sent. The data signal is transferred in sequences of 8 bits.

Arduino i2c example lm75